Recycled Skateboard End Table Top | Stool Top | Wall Art Piece

Side Table Top or Stool Top or Wall Art made out of reclaimed skateboards.

The diameter of the item is approximately 13.75 inches
The thickness is 0.8 inch (or approximately 2.5cm)

LEGS ARE NOT INCLUDED, LISTED AS TOP ONLY:

This is so that you may use your preferred table or stool legs or hang it on your wall with your own hardware. The top is 0.8 inches thick, with a solid plywood core.

*It is recommended to predrill and install screws that go no more than 3/4 inches into the bottom of the piece. The core is made of plywood, coarse-threaded screws are recommended. You may contact me for additional information/guidance on hardware installation recommendations.

Skateboards were cut and glued onto a solid 0.75-inch (approximately 2cm) thick plywood base. the plywood edge is covered with edge banding also made from skateboards

Top is finished with oil based polyurethane, for strong water and scratch resistance.

There are slight variations in the color pattern and edge detail based on the specific item you choose, refer to photos.